This is a migrated thread and some comments may be shown as answers.

How to change the condition of the "If then else" once the steps are recorded?

3 Answers 89 Views
General Discussions
This is a migrated thread and some comments may be shown as answers.
Tester
Top achievements
Rank 1
Tester asked on 17 Dec 2013, 06:49 AM
I have recorder some steps and added If else loop in the steps. If loop is having the condition, i just wanted to change the condition from if statement

3 Answers, 1 is accepted

Sort by
0
Velin Koychev
Telerik team
answered on 19 Dec 2013, 03:40 PM
Hi,

I have recorded a short video to demonstrate you how you can change the Verification. 
You might find also very useful checking our documentation for more information about the logical steps. This article might be also very helpful for you.  

If I am missing something please give us more detailed information.


Regards,
Velin Koychev
Telerik
The New Release of Telerik Test Studio Is Here! Download, install,
and send us your feedback!
0
Tester
Top achievements
Rank 1
answered on 20 Dec 2013, 05:32 AM
Hi Velin,

Thanks for sharing the Video. If i remove the If else loop from the step, the condition inside the if is also removed. So how can i retrieve that step which was if condition.
0
Velin Koychev
Telerik team
answered on 20 Dec 2013, 02:07 PM
Hi,

Currently you are not able to use the same verification step again in your test. You should either record it again or use Step Suggestions  to create it again.

Thank you for your understanding.
 
Regards,
Velin Koychev
Telerik
The New Release of Telerik Test Studio Is Here! Download, install,
and send us your feedback!
Tags
General Discussions
Asked by
Tester
Top achievements
Rank 1
Answers by
Velin Koychev
Telerik team
Tester
Top achievements
Rank 1
Share this question
or