Hi,
I have 2 RadGrids inside separate RadPageView's inside a RadMultiPage with a a RadTabStrip and the whole lot is in a RadWindow.
The first grid has no Command Item Display and fits perfectly. The second grid has the CommandItemDisplay set to Top and now the bottom of the grid is outside the RadPageView border.
How do I set the height of the second RadGrid so that it fits inside the RadPageView even when it has the Command Item Display ?
I have the latest version of 2008.3.1314.35.
Regards
I have 2 RadGrids inside separate RadPageView's inside a RadMultiPage with a a RadTabStrip and the whole lot is in a RadWindow.
The first grid has no Command Item Display and fits perfectly. The second grid has the CommandItemDisplay set to Top and now the bottom of the grid is outside the RadPageView border.
How do I set the height of the second RadGrid so that it fits inside the RadPageView even when it has the Command Item Display ?
I have the latest version of 2008.3.1314.35.
Regards
1 Answer, 1 is accepted
0
Hi Roger,
One possible option in this case would be to set the height of the grid to a value less than 100% - you can distribute the height between the command item and the master table - the total should be equal to 100%. This should allow the control to render normally.
I hope this helps.
Regards,
Yavor
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Check out the tips for optimizing your support resource searches.
One possible option in this case would be to set the height of the grid to a value less than 100% - you can distribute the height between the command item and the master table - the total should be equal to 100%. This should allow the control to render normally.
I hope this helps.
Regards,
Yavor
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Check out the tips for optimizing your support resource searches.