Adam Hubble
Top achievements
Rank 1
Rank 1
Adam Hubble
asked on 03 Apr 2009, 03:23 PM
Hi, I'm sure I have followed the instructions in the documentation for upgrading but the following is happening:
The website works fine if I put the new dll files into the bin folder, however if I set a break point and run in debug mode, Visual Studio seems to replace the new dlls with the old ones and I lose all new skins etc. Why is this happening? I have replaced the dll's, cleared the GAC and added the new dll refs to the GAC but this does not seem to make any difference. The same happens if I do a build.
Any ideas? I'm obviously missing something..
Thanks,
Matt
The website works fine if I put the new dll files into the bin folder, however if I set a break point and run in debug mode, Visual Studio seems to replace the new dlls with the old ones and I lose all new skins etc. Why is this happening? I have replaced the dll's, cleared the GAC and added the new dll refs to the GAC but this does not seem to make any difference. The same happens if I do a build.
Any ideas? I'm obviously missing something..
Thanks,
Matt
1 Answer, 1 is accepted
0
Accepted
Hello Matt,
Do you have a .refresh file in your project? If so, please try to delete it and then add the assemblies to your bin folder again. For your convenience I attached a screenshot illustrating the mentioned file.
Regards,
Daniel
the Telerik team
Check out Telerik Trainer , the state of the art learning tool for Telerik products.
Do you have a .refresh file in your project? If so, please try to delete it and then add the assemblies to your bin folder again. For your convenience I attached a screenshot illustrating the mentioned file.
Regards,
Daniel
the Telerik team
Check out Telerik Trainer , the state of the art learning tool for Telerik products.