When we switched from Q1 to Q2 SP1 we lost the second group of a radgrid that had two groups - one that was not collapsed and one that was. We set the collapse in the code behind. Now the second group does not show up at all.
1 Answer, 1 is accepted
0
Accepted
Pavlina
Telerik team
answered on 04 Sep 2009, 03:39 PM
Hello Zed,
Based on the supplied information, it is hard to determine the cause of the error that you mentioned. If the issue persists, you can open a formal support ticket, and send us a small project, demonstrating the case, for further review.