Hello everybody!
I'm using a Radtreeview with ServerSideCallBack. Actually everything works fine, except one thing:
Whenever I expand one node, I load the childnodes of the childnodes too. This should make it possible to control whether an expand item should bei shown or not. But still the RadTreeView shows a "+" in front of every node. Is there a possibility to control whether the '+' item is shown or not?
Thx in advance & kind regards!
Markus
I'm using a Radtreeview with ServerSideCallBack. Actually everything works fine, except one thing:
Whenever I expand one node, I load the childnodes of the childnodes too. This should make it possible to control whether an expand item should bei shown or not. But still the RadTreeView shows a "+" in front of every node. Is there a possibility to control whether the '+' item is shown or not?
Thx in advance & kind regards!
Markus
1 Answer, 1 is accepted
0
Hi Markus,
You can set ExpandMode property to ClientSide of these nodes only which you want to be without "+" symbol.
Hope this helps.
Regards,
Rosi
the Telerik team
Instantly find answers to your questions at the new Telerik Support Center
You can set ExpandMode property to ClientSide of these nodes only which you want to be without "+" symbol.
Hope this helps.
Regards,
Rosi
the Telerik team
Instantly find answers to your questions at the new Telerik Support Center