Table Paging

[Y]

I am using Telerik Report Designer Q2 2014 trial version.I need support from your end for solving follow problem.



I need to design a report with binding data horizontally on detail section as below



Header1Data11 Data12 Data13

Header2   Data21 Data22 Data23

Header3 Data31 Data32 Data33



So I used
Table/Crosstab for that with rotate layout.This is fine, but when the
records are more then, there is no pagebreak property for
table/crosstab. As expecting suggestion from your side, If I use detail
section for pagebreak, then how can data will bind horizontally on
detail section as below



===============Detail Section==================



Header :  Fields.CompanyName  Fields.CompanyName  Fields.CompanyName



============================================



Straight Forward: Table had 5 records in attached screen shot.I need to get 3 records per page. 



Give me proper suggestion to achieve my desire report layout

[Stef]

Hi,

Please refer to my post in your support ticket #854226 on the same question:

"The Table item is rendered on a single page in Interactive preview, and is paged based on the rules listed in the Understanding Pagination article in Print Preview. If you want to page the report you can set the viewer's ViewMode to PrintPreview.

Depending on the layout you need to achieve, you can also use the approach described in the How to: Create Multi-Column Report - Across the Page and Then Down KB article."

If you need further help, let us continue the discussion in the above mentioned ticket. The thread can be found in your support communication, after logging into your account.

Regards,
Stef
Telerik