Jim Richmond
Top achievements
Rank 1
Rank 1
Jim Richmond
asked on 14 May 2007, 12:28 PM
When I am using a subreport with an ODBC data source, the main report will hang when previewing in design mode if the sub report does not return any data. Has anyone else seen this issue?
1 Answer, 1 is accepted
0
Hi Jim,
This is a well known issue. To fix it try adding a Report Header section to the SubReport and set its height to a low value, for example 0.01mm.
Regards,
Chavdar
the Telerik team
Instantly find answers to your questions at the new Telerik Support Center
This is a well known issue. To fix it try adding a Report Header section to the SubReport and set its height to a low value, for example 0.01mm.
Regards,
Chavdar
the Telerik team
Instantly find answers to your questions at the new Telerik Support Center