This is a migrated thread and some comments may be shown as answers.

Report page margines working not properly

4 Answers 315 Views
General Discussions
This is a migrated thread and some comments may be shown as answers.
Siva
Top achievements
Rank 1
Siva asked on 27 Jul 2012, 01:02 PM
Hi,

 I using Q2 2012 Telerik Reporting. I have a report With 2 sub reports i don't y my margins are not working properly, 
my requirement is report 1st page is default margins like 1in (left, right,top, bottom). from 2nd page on words my page margines decrease to 0.2 in for left and right.

after i tried to main report margins like attachment but report right side margin act's differently.

can you please help me for this issue
 

4 Answers, 1 is accepted

Sort by
0
Steve
Telerik team
answered on 30 Jul 2012, 10:25 AM
Hi Siva,

The screenshot you've sent does not exhibit any problem i.e. in the report designer you've set the margins to 0.2 in and from the looks of the PDF, those margins are respected. It would be best if you elaborate on the problems you've encountered, provide us with steps to reproduce the problem or better yet a sample project that shows it.

Greetings,
Steve
the Telerik team

BLOGGERS WANTED! Write a review about Telerik Reporting or the new Report Designer, post it on your blog and get a complimentary license for Telerik Reporting. We’ll even promote your blog and help bring you a few fresh readers. Yes, it’s that simple. And it’s free. Get started today >

0
Siva
Top achievements
Rank 1
answered on 30 Jul 2012, 03:04 PM
Hi Steve,
Left side margin 0.2 in is good, what ever i set for left it shows like that , if u observe the Screen shot for right side also i set 0.2 in but it shows more thane 1 in , 
i have problem with right side margin, and i want this margins from 2nd page on words, i don't need to 1 st page.

Thanks in advance
0
Steve
Telerik team
answered on 31 Jul 2012, 12:40 PM
Hello Siva,

It is not visible from your screenshot where is the end of the page. You can show the designer snap grid by using the appropriate button from the Report Designer which would show the grid as well as a vertical red line which indicates the end of the physical page i.e. the width you have specified in PageSettings->PaperSize-> Width.
Note that the report width is not equal to the page width i.e. you can have a much thinner report than a physical page. If you want to occupy all of the physical page width, then make sure the report width is the same as the page width (usually a few inches less is advised, in order to avoid horizontal page breaks in some scenarios).

All the best,
Steve
the Telerik team

BLOGGERS WANTED! Write a review about Telerik Reporting or the new Report Designer, post it on your blog and get a complimentary license for Telerik Reporting. We’ll even promote your blog and help bring you a few fresh readers. Yes, it’s that simple. And it’s free. Get started today >

0
Siva
Top achievements
Rank 1
answered on 31 Jul 2012, 02:01 PM
Thank you Steve it's works fine
Tags
General Discussions
Asked by
Siva
Top achievements
Rank 1
Answers by
Steve
Telerik team
Siva
Top achievements
Rank 1
Share this question
or