Telerik Forums / UI for WPF
This is a migrated thread and some comments may be shown as answers.

Q3 Update breaks every single Telerik control

3 Answers 51 Views
General Discussions
This is a migrated thread and some comments may be shown as answers.
Eric
Top achievements
Rank 1
Eric asked on 10 Nov 2014, 07:10 PM
After a simple replace of the DLLs and clean solution, rebuild, nothing works.


WTF!!!  No menu, no buttons, not one single Rad control is visible.

3 Answers, 1 is accepted

Sort by
0
Nikolay
Telerik team
answered on 11 Nov 2014, 07:11 AM
Hi Eric,

Could you, please, check whether you have referenced the Xaml or NoXaml assemblies - this issue would very likely be caused by this. Replacing with the correct set of assemblies should fix it. 

Regards,
Nikolay
Telerik
 

Check out the Telerik Platform - the only platform that combines a rich set of UI tools with powerful cloud services to develop web, hybrid and native mobile apps.

 
0
Eric
Top achievements
Rank 1
answered on 11 Nov 2014, 02:27 PM
Just out of curiosity what is NoXaml used for?

The reason I used this folder is because someone from Telerik sent me an example using the NoXaml folder so naturally I assumed this is the folder to use.
0
Eric
Top achievements
Rank 1
answered on 11 Nov 2014, 03:07 PM
Never mind. I found a link.
Tags
General Discussions
Asked by
Eric
Top achievements
Rank 1
Answers by
Nikolay
Telerik team
Eric
Top achievements
Rank 1
Share this question
or