Numerical Scale CrossAxisPositions set to Auto doesn't always calculate the correct number

[Brent Hetland]

Hi,

I am using Q2 2014 SP1 of your Reporting controls.

I have a Graph that contains a bar series and a line series (I don't know if the line series has anything to do with the problem).

I have one item in my Y-Axis Scale CrossAxisPositions and it's Position is Auto with a Value of 0.

The problem is that with certain ranges of numbers, the X Axis crosses the Y Axis at the MINIMUM value in the data set and because of that, no bar is graphed.

I've attached two pictures to show the problem.  In this case the numbers on the graph chart are all between 1 and 3.  You see that the Auto setting has chosen to make the axis cross at 1.  And you can then see that none of the months with a 1, show a value.  It should cross at 0.  Note that this is NOT the only example I have where it is doing this to me.  I have attached a chart with values between 2 and 12 and the graph chose to cross the axis at 2.  I have attached a picture of that as well.  All the areas where you don't see a bar, are actually a 2 but the user doesn't know that.

Of course I can force this setting to use a Position of "Specific" with a Value of 0, but the Auto setting is nice when numbers are very large (yet all close to each other).

Is there anything I can do to make this work correctly?

Thanks,

Brent

[Stef]

Hello Brent,

Please test using the axis's Scale - CrossAxisPositions to adjust the scale.

In the latest Telerik Reporting Q2 2015 version the Scale properties can be controlled through the Graph - CoordinateSystems - Bindings collection (How to: Use Bindings to Control the Coordinate System Properties).


I hope this information is helpful.

Regards,
Stef
Telerik

[Brent Hetland]

Thank you Stef.  I'll consider upgrading to the latest version.

Regards,

Brent