When trying to read Telerik rad image button in, Command bar UI ,as Automation element, the Enabled state is always returned as True.
Is this automation property supported by the Telerik image button?
I have tested this using RadRichTextEditor sample demo app provided by Telerik and for automation i have used Coded UI .
I tried to fetch the Enabled state of DeleteAll button of Review tab as shown in attached figure, which is always true.
Or which property should be used to get the Enabled status.
as shown in image
Hello jyostna,
Thanks to the provided information I have managed to reproduce your scenario. Upon further investigation, I found out that the Enabled property is not respected in other Telerik UI for WinForms controls as well. This is a general TPF problem, observed when a specific control element is disabled while the parent control is not.
I have logged it in our feedback portal by making this thread public. You can track its progress, subscribe for status changes and add your comments on the following link - feedback item.
I have also updated your Telerik points.
Regards,
Dimitar