Design Mode (VS.NET 2008), properties of the editor, uncheck all editmodes. A zero gets placed in the html (editmodes="0"). Then when you execute the page you get the following error
'EnumConverter' is unable to convert 'Telerik.Web.UI.EditModes' to 'System.ComponentModel.Design.Serialization.InstanceDescriptor'
Not sure why you would ever want to uncheck all of the editmodes, but i did by accecent and it was difficult to find out why i was getting that error.
Version: 2008.3.1125.35
'EnumConverter' is unable to convert 'Telerik.Web.UI.EditModes' to 'System.ComponentModel.Design.Serialization.InstanceDescriptor'
Not sure why you would ever want to uncheck all of the editmodes, but i did by accecent and it was difficult to find out why i was getting that error.
Version: 2008.3.1125.35
1 Answer, 1 is accepted
0
Hi Jason,
Indeed, when you uncheck all of the editor modes you will receive an exception. The reason is because "0" is automatically set as a value of the EditModes property and this is not a valid value.
I suggest you to set at least one Edit Mode because there is no point of using the RadEditor without setting Edit Mode.
All the best,
Nikolay Raykov
the Telerik team
Check out Telerik Trainer, the state of the art learning tool for Telerik products.
Indeed, when you uncheck all of the editor modes you will receive an exception. The reason is because "0" is automatically set as a value of the EditModes property and this is not a valid value.
I suggest you to set at least one Edit Mode because there is no point of using the RadEditor without setting Edit Mode.
All the best,
Nikolay Raykov
the Telerik team
Check out Telerik Trainer, the state of the art learning tool for Telerik products.