Hello everybody,
The customer asked me an application with tabs and docking.
The application is composed by 4 tabs and inside those tabs there are more tabs and in those there are the dockings.
Tab1
Tab2
--TabSub1
----Docking1
--TabSub2
----Docking2
--TabSub2
----Docking3
Tab3
Tab4
When I click on the tab2 I can see everything ok.
If i click on the tab2 and then TabSub3, TabSub1, TabSub2 and afterwards I go to Tab1 and then again in the Tab2 I can see that automatically the TabSubs start to change alone, like if they need to update the docking and then will stop in the last that i select (TabSub2).
There's a solution? I mean, I can say to the Docking to don't request to get "refreshed"? or to don't show that the tabs are moving, like something that you wait until the changes are done and then you show the Tab (In this case the Tab2).
This is the video to show the problem:
http://www.youtube.com/watch?v=3tg4oMOjt6g
The customer asked me an application with tabs and docking.
The application is composed by 4 tabs and inside those tabs there are more tabs and in those there are the dockings.
Tab1
Tab2
--TabSub1
----Docking1
--TabSub2
----Docking2
--TabSub2
----Docking3
Tab3
Tab4
When I click on the tab2 I can see everything ok.
If i click on the tab2 and then TabSub3, TabSub1, TabSub2 and afterwards I go to Tab1 and then again in the Tab2 I can see that automatically the TabSubs start to change alone, like if they need to update the docking and then will stop in the last that i select (TabSub2).
There's a solution? I mean, I can say to the Docking to don't request to get "refreshed"? or to don't show that the tabs are moving, like something that you wait until the changes are done and then you show the Tab (In this case the Tab2).
This is the video to show the problem:
http://www.youtube.com/watch?v=3tg4oMOjt6g