What I am trying to achieve is simply a cascade parameter report but I am not succeeding.
I have a table where I have several columns and two of these in the same table are the parameters I need to use: Country and Type.
Attached there are pictures showing how I have structured the two parameters and the filters.
The first parameter is populating (Country) but the second parameter (Type) does not show any Type after any of the country gets selected.
Your help will be really appreciated.
Thanks,
Felice
I have a table where I have several columns and two of these in the same table are the parameters I need to use: Country and Type.
Attached there are pictures showing how I have structured the two parameters and the filters.
The first parameter is populating (Country) but the second parameter (Type) does not show any Type after any of the country gets selected.
Your help will be really appreciated.
Thanks,
Felice
1 Answer, 1 is accepted
0
Hello Felice,
Based on the provided code snippets we have noticed that second parameter Filter is wrong you are trying to compare Type to Country but instead it should look as shown below:
=Fields.Country = =Parameters.Country.Value
Additionally you may find useful the How to: Cascading Parameters with applied filtering on Report level help article.
Regards,
Peter
Telerik
Based on the provided code snippets we have noticed that second parameter Filter is wrong you are trying to compare Type to Country but instead it should look as shown below:
=Fields.Country = =Parameters.Country.Value
Additionally you may find useful the How to: Cascading Parameters with applied filtering on Report level help article.
Regards,
Peter
Telerik
DevCraft Q1'14 is here! Watch the online conference to see how this release solves your top-5 .NET challenges. Watch on demand now.