This is a migrated thread and some comments may be shown as answers.

Where do i find it ?

3 Answers 121 Views
General Discussions
This is a migrated thread and some comments may be shown as answers.
Kenneth Jackson
Top achievements
Rank 1
Kenneth Jackson asked on 18 Jan 2008, 10:51 AM
I recently purchased the telerik controls but nowhere can i find the radrotator or the statusstrip or the colordialog controls mentioned here for winforms.

I dont see any code samples for them in the sample app either

What am i missing ?

3 Answers, 1 is accepted

Sort by
0
Kiril
Telerik team
answered on 18 Jan 2008, 12:26 PM

Hello Kenneth Jackson,

Thank you for writing.

Could you confirm that you're using our Q3 2007 release?

I looked into the issue you reported and found out the folders where the example code is located do not follow the folder structure in the examples application.

The following solution assumes you installed our product in the C:\Program Files\Telerik folder. If you installed it in an alternative folder, please replace this part of the path with the folder where our controls are installed.

Please find the code for the examples you requested under the following locations:

  • RadColorSelector
    C:\Program Files\Telerik\RadControls for WinForms Q3 2007\Examples\UIElements\RadColorSelector
  • StatusStrip
    C:\Program Files\Telerik\RadControls for WinForms Q3 2007\Examples\UIElements\StatusStrip
  • Rotator
    C:\Program Files\Telerik\RadControls for WinForms Q3 2007\Examples\UIElements\Rotator

Thank you very much for bringing this up. This will be addressed in our upcoming version, so as to remove any chance for a mixup.

Greetings,
Kiril
the Telerik team

Instantly find answers to your questions at the new Telerik Support Center
0
Kenneth Jackson
Top achievements
Rank 1
answered on 20 Jan 2008, 12:48 PM
Thank you for your help.

It seems I wasnt paying attention to version and did not have q3 installed.
I have since done so , but now i want the controls in my project to reference
the new q3 versions .

It still seems that the project references my q2 version. I've tried
changing the reference paths but then it just says it can't find the references.
The paths are all correct , what else do I need to do to change to the newer
versions ?

0
Kenneth Jackson
Top achievements
Rank 1
answered on 20 Jan 2008, 12:53 PM
Ignore that last question :) I'm simply not paying attention.

Tags
General Discussions
Asked by
Kenneth Jackson
Top achievements
Rank 1
Answers by
Kiril
Telerik team
Kenneth Jackson
Top achievements
Rank 1
Share this question
or