This is a migrated thread and some comments may be shown as answers.

The diagram ruler overlapping!

2 Answers 7 Views
Diagram
This is a migrated thread and some comments may be shown as answers.
wu
Top achievements
Rank 1
Veteran
wu asked on 20 Apr 2019, 12:32 AM

when zoom out the diagram drawing area,if the zoom factor is small,the ruler will overlapping.

2 Answers, 1 is accepted

Sort by
0
Vladimir Stoyanov
Telerik team
answered on 24 Apr 2019, 10:26 AM
Hello,

The described behavior is the expected one, since the RadDiagramRuler control works with ScaleDefinitions which define the tick intervals used for all zoom levels.

If you do not wan't the labels to be overlapped at some point, when you change the DiagramConstants.Maximum/Minimum properties, you can include additional scale definitions for the new zoom range. By default the ruler contains definition for zoom levels between 1 and 5. You can read more about this in the Ruler help article.

I hope you find this helpful.

Regards,
Vladimir Stoyanov
Progress Telerik
Get quickly onboarded and successful with your Telerik and/or Kendo UI products with the Virtual Classroom free technical training, available to all active customers. Learn More.
0
wu
Top achievements
Rank 1
Veteran
answered on 28 Apr 2019, 05:30 AM

oh,  i thought it like the microsofr visio's zoom,or like your chart datatime axis,it can adjust the ruler automated with zoom

 

Tags
Diagram
Asked by
wu
Top achievements
Rank 1
Veteran
Answers by
Vladimir Stoyanov
Telerik team
wu
Top achievements
Rank 1
Veteran
Share this question
or