Printed report != designed report

[Andreas]

Howdy,

So, like the title says - I have a simple report which uses the Report Header section to display a graphic. The header also has a border around it, as does the detail section. In design as well as during runtime it looks good - however, open print preview and it all goes down hill :)

I've attached two screenshot that show the issue. I've seen similar behavior when controls overlap etc - but there is none of that in this report (at least as far as I can tell.)

Regards,

Andreas

[IvanY]

Hi Andreas,

We were not able to reproduce such a behavior as the default one is to match the width of all of the three sections: detail, page header/footer, report header/footer. Therefore we will need additional information about your setup in order to advise you accordingly. It will be best if you are able to provide us with a runnable sample that exhibits the issue so that we are able to reproduce the issue at our end, which will speed up identifying the culprit.

Regards,
IvanY
the Telerik team