Orthogonal line

[Lee]

Hello, I'm HeeJun.

I wonder one thing.

It's about 'Line' object in 'RadDiagram' control.

But, I can't draw beeline. ( straight,  perpendicular etc... , angle 90' )

Currently, I'm using the object as connection between two rectangle.

I try correction it, but position is incorrect in 'RadDiagram' control.

When it can be. Or what should I do?

Thank you.

[Petar Mladenov]

Hello Lee,

We are unable to understand what is your exact requirement. We encourage you to check out the Connections Help article which describes:
- the 3 connection types  - Polyline, Bezier, Spline
- how to set up connections - source, target, content, cap types
- how to customize the connections apperance

Also, the routing help article elaborates on the ways to use connection routing - the mechanism which routes the connections between shapes.

If the above articles do not help, you can send us some snapshots / steps of the desired customization you need - visual or functional. This way we would be better able to advice you.

Regards,
Petar Mladenov
Telerik