I apologize if this has been brought up before and I missed it.
Setup an ObjectDataSource with run-time and design-time parameters. It all looks good.
Now change the design-time parameters. On closing the wizard, the datasource is queried using the original values.
Go back into the wizard and just progress through to Finish. The datasource is re-queried using the new/current values.
Is anyone else noticing that in the current release? (7.0.13.220)
This is happening to me a lot, in different projects, and over periods of time, reboots, etc.
Thanks.
Setup an ObjectDataSource with run-time and design-time parameters. It all looks good.
Now change the design-time parameters. On closing the wizard, the datasource is queried using the original values.
Go back into the wizard and just progress through to Finish. The datasource is re-queried using the new/current values.
Is anyone else noticing that in the current release? (7.0.13.220)
This is happening to me a lot, in different projects, and over periods of time, reboots, etc.
Thanks.
1 Answer, 1 is accepted
0
Hello Tony,
We have verified that there is an issue with the design-time parameters and we have logged it in our data-base for further investigation.
As a token of our gratitude we have updated your account with some Telerik points.
Greetings,
Elian
the Telerik team
We have verified that there is an issue with the design-time parameters and we have logged it in our data-base for further investigation.
As a token of our gratitude we have updated your account with some Telerik points.
Greetings,
Elian
the Telerik team
Have you tried the new visualization options in Telerik Reporting Q1 2013? You can get them from your account.