I have a report (attached screenshot of the designer), I have the page set up to A4 Portrait, 210mm wide, 297mm high, left and right margins at 8mm each. The report is set at a width of 190mm so should fit fine as was working until I made some changes to the table (added 2 columns and set its width to 190mm) at wich points 2 panels I had above the table on the right on the document started being pushed on to a new page showing on the left of that new page. I tired moving them and the rest to the report header leaving the table in the detail, putting the table in a panel and removing the table, but the only thing that worked is moving the two panels so that they were 25mm from the right edge. In the PDF however they show up right against the edge in the same location as they were before they started getting pushed onto a new page.
1 Answer, 1 is accepted
0
Mark
Top achievements
Rank 1
Rank 1
answered on 02 Aug 2016, 03:32 PM
Solved it, it seems to have been caused by the image in the upper left being set to auto size, if I manually set it to the pixel size of the image it works fine.