This is a migrated thread and some comments may be shown as answers.

Blank First Page

2 Answers 94 Views
General Discussions
This is a migrated thread and some comments may be shown as answers.
Darren
Top achievements
Rank 1
Darren asked on 06 Nov 2009, 01:08 PM
Hi,

I am working on a report with multiple sub-reports.  If either of the bottom two reports are visible all the report content gets pushed to then next page.  I have no idea what is causing this.  I checked the widths and the margins.  What else should I look at?

Thanks,
Darre

2 Answers, 1 is accepted

Sort by
0
Steve
Telerik team
answered on 09 Nov 2009, 09:45 AM
Hi Darren ,

Did that start when you have changed anything in your project? Also in what format does that carry over occur? Have you played around with the KeepTogether properties of the detail section and subreport items themselves to see if that would make a difference.
If still having problems it would be best if you prepare a sample project that shows the erroneous behavior you talk about.

Regards,
Steve
the Telerik team

Instantly find answers to your questions on the new Telerik Support Portal.
Watch a video on how to optimize your support resource searches and check out more tips on the blogs.
0
Darren
Top achievements
Rank 1
answered on 10 Nov 2009, 02:11 PM
I had to set keep together to false on just about everything, make the columns all the same width, and make the subreport control much narrower than the actual report to get the columns to line up.  It was a very painful process.
Tags
General Discussions
Asked by
Darren
Top achievements
Rank 1
Answers by
Steve
Telerik team
Darren
Top achievements
Rank 1
Share this question
or