This is a migrated thread and some comments may be shown as answers.

Add new BO properties to Data Explorer?

1 Answer 16 Views
General Discussions
This is a migrated thread and some comments may be shown as answers.
Matthew Kwan
Top achievements
Rank 1
Matthew Kwan asked on 06 Dec 2009, 12:50 AM
Hi, I am using BO as the datasource.

Initially the BO has 5 properties, when I created the report using it as datasource, the data explorer shows the 5 properties.

Then I added additional 3 properties to the BO, how do I refresh the report so that the new 3 properties are showing up in the data explorer?

Regards,
Matthew

1 Answer, 1 is accepted

Sort by
0
Chris Gillies
Top achievements
Rank 1
answered on 07 Dec 2009, 07:52 AM
Rebuilding the entire solution should probably do it. If it does not, use the DataSource wizard to set the BO as datasource again.
Tags
General Discussions
Asked by
Matthew Kwan
Top achievements
Rank 1
Answers by
Chris Gillies
Top achievements
Rank 1
Share this question
or