TechSavvySam
Top achievements
Rank 1
Rank 1
TechSavvySam
asked on 21 Sep 2010, 08:29 PM
In the Telerik Trainer Session:
Telerik Reporting:
you have the video, which plays poorly and is available on Telerik TV and NO CODE. What is the point of putting it in Telerik trainer if there is no source code?
Telerik Reporting:
Reporting — Subreports
you have the video, which plays poorly and is available on Telerik TV and NO CODE. What is the point of putting it in Telerik trainer if there is no source code?
3 Answers, 1 is accepted
0
Hi Sam,
The source for the video you've watched is part of our Telerik Trainer tutorials and its code is available on our site here: Telerik Reporting Trainer Tutorials.
Best wishes,
Steve
the Telerik team
Check out Telerik Trainer, the state of the art learning tool for Telerik products.
The source for the video you've watched is part of our Telerik Trainer tutorials and its code is available on our site here: Telerik Reporting Trainer Tutorials.
Best wishes,
Steve
the Telerik team
Check out Telerik Trainer, the state of the art learning tool for Telerik products.
0
TechSavvySam
Top achievements
Rank 1
Rank 1
answered on 24 Sep 2010, 04:03 PM
I downloaded that Trainer module and the "code" button in Telerik trainer was grayed out when viewing that video.
0
Hi Sam,
Should you forward the video after the introduction section, where explanation about the actual sample project starts, the code button becomes active and clicking on it would load the project in Visual Studio.
Let us know if further help is needed.
Regards,
Steve
the Telerik team
Check out Telerik Trainer, the state of the art learning tool for Telerik products.
Should you forward the video after the introduction section, where explanation about the actual sample project starts, the code button becomes active and clicking on it would load the project in Visual Studio.
Let us know if further help is needed.
Regards,
Steve
the Telerik team
Check out Telerik Trainer, the state of the art learning tool for Telerik products.