Hi there!
I'm using the RadControls for Winforms Version 2008.3 1105 Trial release under Windows Vista Business Premium, facing the following problem:
If I have more than one tabbed documents (Tool Windows) in a DockingManger and I'm switching between the different tabs (by clicking the tab header or using the "documents" pull down menu in the docking manager) I'm no more able to activate some windows, one of them wins and stays active all the time.
You can easily reproduce this behavior in the RadDock -> Tabbed Document sample in the RadControl for Winforms Example application provided with the trial. Lauch the Tabbed Document sample and click through the tabs from left to right. After you did activate one of the two "Document Windows" no one of the two "Tool Windows" will be shown anymore, even if the log says they have been activated.
I'm quite shure this was not the case in the previous release.
Are you able to confirm (and to solve) this problem? This would be great especially because my company thinks about purchasing the controls if they work fine :)
Regards,
ReneMT
I'm using the RadControls for Winforms Version 2008.3 1105 Trial release under Windows Vista Business Premium, facing the following problem:
If I have more than one tabbed documents (Tool Windows) in a DockingManger and I'm switching between the different tabs (by clicking the tab header or using the "documents" pull down menu in the docking manager) I'm no more able to activate some windows, one of them wins and stays active all the time.
You can easily reproduce this behavior in the RadDock -> Tabbed Document sample in the RadControl for Winforms Example application provided with the trial. Lauch the Tabbed Document sample and click through the tabs from left to right. After you did activate one of the two "Document Windows" no one of the two "Tool Windows" will be shown anymore, even if the log says they have been activated.
I'm quite shure this was not the case in the previous release.
Are you able to confirm (and to solve) this problem? This would be great especially because my company thinks about purchasing the controls if they work fine :)
Regards,
ReneMT
1 Answer, 1 is accepted
0
Hi renemt,
The problem is already resolved. The fix will be available for Q3 SP1 release, planned for the end of this week.
Thank you for the reported issue. Your Telerik points have been updated.
Kind regards,
Julian Benkov
the Telerik team
Check out Telerik Trainer, the state of the art learning tool for Telerik products.
The problem is already resolved. The fix will be available for Q3 SP1 release, planned for the end of this week.
Thank you for the reported issue. Your Telerik points have been updated.
Kind regards,
Julian Benkov
the Telerik team
Check out Telerik Trainer, the state of the art learning tool for Telerik products.