Hi!
Don't know how to describe this but I give it a go ..
I reinstalled my PC and installed Telerik WinForms ... ofc same version as I used pre-reinstall.
I open my project and try to select a radcontrol currently on form but it refuses to be selected.
Whern I try to add a new control by db-cklick lets say RadPageView .. it never end up on my form. Instead I see it belowq the form as a control (control widowd where I use to see BackGroundWorker etc)
Normal controls work fine.
Pls help ...
//Henrik
Don't know how to describe this but I give it a go ..
I reinstalled my PC and installed Telerik WinForms ... ofc same version as I used pre-reinstall.
I open my project and try to select a radcontrol currently on form but it refuses to be selected.
Whern I try to add a new control by db-cklick lets say RadPageView .. it never end up on my form. Instead I see it belowq the form as a control (control widowd where I use to see BackGroundWorker etc)
Normal controls work fine.
Pls help ...
//Henrik
1 Answer, 1 is accepted
0
Hi Henrik,
Thank you for writing.
Please refer to the following article which concerns your case and the possible solution:
RadControls for WinForms are not loaded at design-time.
I hope this helps.
Kind regards,
Nikolay
the Telerik team
Thank you for writing.
Please refer to the following article which concerns your case and the possible solution:
RadControls for WinForms are not loaded at design-time.
I hope this helps.
Kind regards,
Nikolay
the Telerik team
Register for the Q2 2011 What's New Webinar Week. Mark your calendar for the week starting July 18th and book your seat for a walk through of all the exciting stuff we will ship with the new release!