I have set the visibility of a rad grid to false on load of a winform.
when a check box toggle state occurs i use the following code
however this does not work when i step to next line and check the visibilty of the radgrid, it is still false !!!!!!
is this a known issue, i seem to be having a lot of problems with the telerik winforms controls q3 2008
when a check box toggle state occurs i use the following code
| radgrid1.Visible = true; |
is this a known issue, i seem to be having a lot of problems with the telerik winforms controls q3 2008
1 Answer, 1 is accepted
0
Hi Roy,
Thank you for contacting us.
This is not a known issue and I was not able to reproduce it. Could you please open a support ticket and send us the source code of your application. This will help us investigate the issue and find a proper solution for you.
If you need any further assistance, please don't hesitate to write us.
Best wishes,
Jack
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Check out the tips for optimizing your support resource searches.
Thank you for contacting us.
This is not a known issue and I was not able to reproduce it. Could you please open a support ticket and send us the source code of your application. This will help us investigate the issue and find a proper solution for you.
If you need any further assistance, please don't hesitate to write us.
Best wishes,
Jack
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Check out the tips for optimizing your support resource searches.