I am trying out JustMock, so maybe I have made some beginners mistake. But I cannot get tests to run with coverage.
I am using: VS2019 16.0.4, Just Mock 2019.2.508.1 (in Trial mode), ReSharper / DotCover 2019.1.1. JustMock has been linked to both DotCover and VS2019 Code Coverage.
I normally run with the ReSharper test runner and use DotCover for coverage. That works OK for JustMock with the profiler disabled with or without coverage or with the profiler enabled but then only without code coverage.
DotCover "Cover all tests" hangs after the build with all unit tests shown as pending. VS GUI is responsive, about 5% CPU load, but nothing is happening.
I also tested the built in VS test runner and coverage measurement. Same picture test runs OK as long as you do not ask for coverage. Use "Analyze code coverage > All tests" in VS gives the same behavior as with the ReSharper / DotCover.
Any suggestions?
/Mats