This question is locked. New answers and comments are not allowed.
Ben Lischner
Top achievements
Rank 1
Rank 1
Ben Lischner
asked on 17 Dec 2009, 06:54 PM
It appears that with Q3, tabbing no longer only tabs between cells not marked as read only. Is there a way in Q3 to skip over read only cells when tabbing?
1 Answer, 1 is accepted
0
Hi Ben Lischner,
Generally when current GridViewCell is in edit mode and you press TAB key next "editable" cell will become current and will enter into edit mode. The picture is a little bit different when current cell is not in edit mode, then TAB key just moves focus to next cell. We are doing our best to introduce some improvements to the keyboard navigation with the next official release or service pack, which will allow you to customize behavior of any key including TAB.
Sincerely yours,
Nedyalko Nikolov
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Watch a video on how to optimize your support resource searches and check out more tips on the blogs.
Generally when current GridViewCell is in edit mode and you press TAB key next "editable" cell will become current and will enter into edit mode. The picture is a little bit different when current cell is not in edit mode, then TAB key just moves focus to next cell. We are doing our best to introduce some improvements to the keyboard navigation with the next official release or service pack, which will allow you to customize behavior of any key including TAB.
Sincerely yours,
Nedyalko Nikolov
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Watch a video on how to optimize your support resource searches and check out more tips on the blogs.