This question is locked. New answers and comments are not allowed.
I had occasion to reset my VS toolbox and, consequently run the option to register the controls.
I noticed that this fired up devenv and JC. The process seemed to complete but devenv didn't exit and, when I fired up devenv manually the toolbox tab I was expecting wasn't there. Being of a suspicious nature, I killed all the devenv processes, fired up VS, stopped JC from loading on startup, came out and ran the register option again.
And lo, devenv started, and closed. And when I started VS, the toolbox was there, hurrah!
And the lesson? Whatever it is that the register option does, it needs to make sure it does it with JC disabled.
--
Stuart
I noticed that this fired up devenv and JC. The process seemed to complete but devenv didn't exit and, when I fired up devenv manually the toolbox tab I was expecting wasn't there. Being of a suspicious nature, I killed all the devenv processes, fired up VS, stopped JC from loading on startup, came out and ran the register option again.
And lo, devenv started, and closed. And when I started VS, the toolbox was there, hurrah!
And the lesson? Whatever it is that the register option does, it needs to make sure it does it with JC disabled.
--
Stuart