JC is making a terrible job of updating the Errors window

[Stuart Hemming]

Please see the attached.

I have the window set to auto-hide (as I have all the other windows). You can see from the image that the list is badly drawn and the buttons at the top (Errors, Warnings, etc) are missing. What might not be quite so apparent is that all these errors are old ones cleared up some time previously. You can see a hint of that from the bottom left corner where you'll notice that JC is reporting no errors.

It is prolly worth pointing out the none of the other windows display this behaviour, just JC.
-- 
Stuart

[Stuart Hemming]

Hi,

I found this thread that made a suggestion about dealing with the poor rendering, and that has made a big difference. However, now the grid is drawing properly but it is still showing a bunch of old errors some of them referring to code that is no longer even there!

-- 
Stuart

[Stuart Hemming]

Hmmm. Reloading the project this morning has cleared the problem of the old errors being reported.

Go figure.

-- 
Stuart

[Hans Kratz]

Hello Stuart,

thanks for reporting this.

The error list and the status bar should be out of sync only for a few seconds at most. If they are continuously out of sync we have a new issue. Can you keep an eye on this if it occurs again.

Everybody else reading this if you are also having the situation where the status bar reports a different number of errors than the JustCode error window please tell us.

Best wishes,
Hans Kratz
the Telerik team

[Stuart Hemming]

> Can you keep an eye on this if it occurs again.
You can be sure of it.

-- 
Stuart