This question is locked. New answers and comments are not allowed.
Hi:
I have a number of charts on separate RadDocumentPanes. I only bind to the data source the first time each tab is displayed, but when i click on a previously visible tab, the animation, adding one bar at a time happens again, How can I disable this so that the animation only occurs once?
I have a number of charts on separate RadDocumentPanes. I only bind to the data source the first time each tab is displayed, but when i click on a previously visible tab, the animation, adding one bar at a time happens again, How can I disable this so that the animation only occurs once?
1 Answer, 1 is accepted
0
Hi Terry,
Indeed there was a problem with bar animation restarting when re-opening tabs in RadTabControl multiple times. Our developers managed to address this issue and the problem is resolved in the latest official release Q3 2009 SP2 (v2009.3.1314.1030).
Kind regards,
Manuel
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Watch a video on how to optimize your support resource searches and check out more tips on the blogs.
Indeed there was a problem with bar animation restarting when re-opening tabs in RadTabControl multiple times. Our developers managed to address this issue and the problem is resolved in the latest official release Q3 2009 SP2 (v2009.3.1314.1030).
Kind regards,
Manuel
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Watch a video on how to optimize your support resource searches and check out more tips on the blogs.