andrew rekvils
Top achievements
Rank 1
Rank 1
andrew rekvils
asked on 29 Jul 2009, 07:19 PM
I am having my expander inside a UserControl and expander content has few simple controls. Initial state of the expander is IsExpanded=false. Nevertheless every time I bring up my UserControl expander's content is blinking as if it shows all its content first and then realizes it's supposed to be in IsExpaned=false state and hide it. Is there is way to avoid blinking here?
Thank you,
Andrew
Thank you,
Andrew
1 Answer, 1 is accepted
0
Hi Andrew,
Thank you for your interest in the RadExpander control.
Actually the initial blinking of an collapsed expander was an issue with the previous version. With the last release there should not be such a case. As a proof you can try the attached example - it was built with the last official Q2 (07-01-2009) version.
We hope this information will help you.
Kind regards,
Ivan
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Check out the tips for optimizing your support resource searches.
Thank you for your interest in the RadExpander control.
Actually the initial blinking of an collapsed expander was an issue with the previous version. With the last release there should not be such a case. As a proof you can try the attached example - it was built with the last official Q2 (07-01-2009) version.
We hope this information will help you.
Kind regards,
Ivan
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Check out the tips for optimizing your support resource searches.