Hello again,
I'm having another problem with single data point series on the XValue. It seems that if I have a series with a single data point, the XValue for that data point is ignored and set to 0. For example, if I have a bubble chart where I add 25 series, each with a single data point that contains an incrementing value, you would expect the following:
0,0
1,1
2,2
3,3
4,4
etc...
but instead I get...
0,1
0,2
0,3
0,4
...
Basically instead of a linerar line of bubbles I get a column of bubbles. Now if I take the same data points and combine them into a single series, I get the expected result.
Why is the XValue ignored in a single point data series, or am I going about this wrong?
Thanks for your time.
1 Answer, 1 is accepted
0
Hello Nathan,
The current official version of the RadChart ignores the XValue of the DataPoint. For the Q2 2009 (scheduled for July, 2009) support for X values will be added.
Sincerely yours,
Evtim
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Check out the tips for optimizing your support resource searches.
The current official version of the RadChart ignores the XValue of the DataPoint. For the Q2 2009 (scheduled for July, 2009) support for X values will be added.
Sincerely yours,
Evtim
the Telerik team
Instantly find answers to your questions on the new Telerik Support Portal.
Check out the tips for optimizing your support resource searches.