This question is locked. New answers and comments are not allowed.
Why is it that when I cut and paste my radchart in VS2008 (from one teleriki...ui.TabItem on the form to another on the same form) it buggers my settings for the chart. the first time I did it it automatically added new series that wern't there before, changed the type to spline area from spline... arrggh!!! I found several other similar quirks which have caused me to have to redo- this same chart 3 times now. it has become an $%(#*($ exercise in frustration!!
sorry for the vent.
is this one of microsofts vs2008 special features or something more local?
(ps the final chart does look pretty $(#* awesum mind you :)
regards
ewart
sorry for the vent.
is this one of microsofts vs2008 special features or something more local?
(ps the final chart does look pretty $(#* awesum mind you :)
regards
ewart
1 Answer, 1 is accepted
0
Hi ewart,
I was able to reproduce the part of the issue that describes adding extra series. It will be addressed for one of our next releases.
Actually, I could not reproduce the the issue where RadChart type changes to Spline Area from Spline Line. Could you please open a new support ticket and send me a sample project that demonstrates the described behavior?
I am looking forward to your response.
Kind regards,
Nikolay
the Telerik team
Instantly find answers to your questions at the new Telerik Support Center
I was able to reproduce the part of the issue that describes adding extra series. It will be addressed for one of our next releases.
Actually, I could not reproduce the the issue where RadChart type changes to Spline Area from Spline Line. Could you please open a new support ticket and send me a sample project that demonstrates the described behavior?
I am looking forward to your response.
Kind regards,
Nikolay
the Telerik team
Instantly find answers to your questions at the new Telerik Support Center