Debug edit and continue (Not Working)

[Dat]

Hi,

Since, I have installed Telerik JustCode on VS2010 (32 bit) Windows 7 32 Bit, when I am debugging I get an Error Message:
Edit and Continue
Changes are not allowed in the following cases:
- When the debugger has been attached to an already running process.
- The code being debugged was optimized at build or run time.
- The assembly being debugged is loaded as domain-neutral.
- The assembly being debugged was loaded through reflection.

I want to have the original ability if an error occurr I can edit and continue.
I think it is caused by the JustCode.

Please Advice how to fix it or how to Disable JustCode.
Thanks.
Regards Dat.

[Zdravko]

Hi,

 Thanks for contacting us.
I am not sure this is caused by JustCode, but we can check this. You can disable JustCode from VS Tools menu > Add-in Manager.
Would you send me your logs located at %localappdata%\JustCode\Logs in case there is anything suspicious?
Thanks.

All the best,
Zdravko
the Telerik team

[Dat]

Dear Support,

I've Identified the issue with VS 2010, just incase someone else run into the same problem.

There is a setting in Visual Studio 2010 when debug it would "Attach" Externally which would stop "Edit and Continue" to work.

I can't seem to find this setting anymore, could you help me find this setting please.

Thanks.
Regards Dat.

[Zdravko]

Hi,

Thanks for getting back to us.
Maybe you are looking for this VS Options page ?
Thanks.

Regards,
Zdravko
Telerik