Hey Telerik,
I was hoping you could clear something up for me. I'm looking to set a property for tabindex on Radcheckboxelement, but there is no such property to set. Is there a way to set this to allow tab stops, etc?
Thanks!
Jim
1 Answer, 1 is accepted
0
Martin Vasilev
Telerik team
answered on 28 Jan 2009, 02:35 PM
Hello gdijim,
Thank you for writing.
TabStop property is not supported for the elements, but only for controls, since you can tab only from a control to a control, not from an element to another element in one and the same control.
Since this forum thread is in the RadRibbonBar section, I suppose that you want to tab through the elements in the RadRibbonBar control. As I mentioned, you cannot tab through the elements, but for RadRibbonBar you should use key tips and short cuts instead. This comes from the design specifications of Microsoft.
Do not hesitate to contact me again, if you have other questions.
Best wishes,
Martin Vasilev
the Telerik team
Check out Telerik Trainer, the state of the art learning tool for Telerik products.