This question is locked. New answers and comments are not allowed.
Josh Anderson
Top achievements
Rank 1
Rank 1
Josh Anderson
asked on 30 May 2008, 02:37 PM
I don't know if this is specific to my system, but any time I perform a cut-and-paste operation with a radTabStrip, the pasted radTabStrip loses all the controls that were in the tabs.
To test, add a radTabStrip to a form, create two tabs, then add some controls to each tab. Select the radTabStrip and perform a cut operation via Ctrl-X. Paste the radTabStrip back onto the form via Ctrl-V. The controls added to the tab pages are not present.
Josh
To test, add a radTabStrip to a form, create two tabs, then add some controls to each tab. Select the radTabStrip and perform a cut operation via Ctrl-X. Paste the radTabStrip back onto the form via Ctrl-V. The controls added to the tab pages are not present.
Josh
1 Answer, 1 is accepted
0
Hello Josh Anderson,
Thank you for the report.
This is a known issue and it will be addressed in one of our upcoming releases.
If you have additional questions, do not hesitate to contact me.
Sincerely yours,
Nikolay
the Telerik team
Instantly find answers to your questions at the new Telerik Support Center
Thank you for the report.
This is a known issue and it will be addressed in one of our upcoming releases.
If you have additional questions, do not hesitate to contact me.
Sincerely yours,
Nikolay
the Telerik team
Instantly find answers to your questions at the new Telerik Support Center